fpt and WinFPT Reference Manual - Command-line Commands
| SimCon Home | Ref Manual Home |
CHANGE HEX NUMBERS
CHANGE HEX [NUMBERS] TO DEC [FORMAT]
CHANGE HEX [NUMBERS] TO FORTRAN 90 [FORMAT]
CHANGE HEX [NUMBERS] TO GOULD-SEL [FORMAT]
CHANGE HEX [NUMBERS] TO IBM [FORMAT]
CHANGE HEX [NUMBERS] TO INTEL [FORMAT]
CHANGE HEX [NUMBERS] TO SALFORD [FORMAT]
CHANGE HEX [NUMBERS] TO TOP[ ]EXPRESS [FORMAT]
CHANGE HEX [NUMBERS] TO X'FFFF'
CHANGE HEX [NUMBERS] TO 'FFFF'X
CHANGE HEX [NUMBERS] TO Z'FFFF'
CHANGE HEX [NUMBERS] TO 'FFFF'Z
DO NOT CHANGE HEX NUMBERS
HEX NUMBERS AS WRITTEN
fpt reads HEX numbers in all of the formats listed above. These commands instruct fpt systematically to convert HEX numbers to the specified formats. Some of the formats are synonyms. They are, for example:
Octal numbers may similarly be changed by the command CHANGE OCTAL NUMBERS.
Note that no attempt is made to byte-swap the numbers in changing between big-ended and little-ended systems.
Changed HEX numbers are marked by diagnostics in the code. These may be suppressed by the SUPPRESS ERROR command.
Where to Use this Command
|Operating system command line||Yes|
|Configuration file, config.fsp||Yes|
|Specification (fsp) files, *.fsp||Yes|
|Interactively, to FPT> prompt||Yes|
|Interactive command files||Yes|
|Embedded in the Fortran code||No|
HEX numbers are not changed by default (Note that defaults may be changed in the configuration file).
Copyright ©1995 to 2018 Software Validation Ltd. All rights reserved.